ACOME
Complete systems for: radiant floor heating/cooling/plumbing.
Plumbing systems Hot and cold water distribution
Principle: The appliances (plumbing, radiators, fan-coil units, etc.) are individually supplied from a header / distributor. Direct connection, without discontinuity or couplings, is done by ducted PEX-c or PB pipes incorporated into the structures (see diagrams) or by surface-mounted multi-layers.
A complete system The components: · PEX-c, PB or multi-layer pipes (with or without ducts) which meet with international requirements (see page 4, pipes can be supplied by ACOME). · Complete range of NF or DIN crimped fittings · Accessories for inlets and outlets in structures · Header / Distributor · Valves and accessories · Manual or battery-operated crimping guns
A large number of advantages: · Easy installation = less time required Fewer nuisances = absorption of circulation area noises, decreased heat losses · Increased safety = elimination of pipework corrosion and furring · Complete system with adapted components that comply with regulatory restrictions.
DEPARTMENT BUILDINGS - 52, rue du Montparnasse - 75014 Paris - France - Tél. : +(33) 1 42 79 14 00 - Fax : +(33) 1 42 79 15 00 E-Mail : DBAT@acome.fr - Site : www.acome.com Réf. DBAT 02/2005 - 253 AN - 991188
Hydraulic and electric Four comple
Hydraulic under floor heating / cooling Installed with a concrete slab or a wet screed
Skirting Permanent elasticity joint
ACOME under floor heating systems are used to provide total or partial heating or heating/coolin apartment blocks, and in the business sector: offices and factories. They are fully adapted to schoo stadiums. They can also be used outdoors to prevent the formation of black ice, as solar panels, etc
Anti-shrinkage web (if required) Concrete slab or wet screed
WALL / PARTITION
Peripheral insulation PEX-c pipe Floor finish
Isolation slab on pads
Support
More than 20 years experience and references: over 30,000,000 m2 of Acome floors have been laid across the world Hydraulic under floor heating Dry solution, installed without any concrete
Innovation prizes Nominated at the Paris international Interclima 2004 trade show Installed within 22 mm!
Skirting Permanent elasticity joint Peripheral insulation
WALL / PARTITION
2 PEX-c pipes PE /aluminium undercoat Floating floor
PSE slab with aluminium film
al thi Re
Support
22 m
· Thin system: taking 22 m · Lightweight system: very · System that can be laid o · Easy system: very quick i · Dry system: premises are
DEPARTMENT BUILDINGS - 52, rue du Montparnasse - 75014 Paris - France - Tél. : +(33) 1 42 79 14 00 - Fax : +(33) 1 42 79 15 00 E-Mail : DBAT@acome.fr - Site : www.acome.com Réf. DBAT 02/2005 - 253 AN - 991188
c under floors heating ete systems
Electric under floor heating, permanent output cable Installed with a concrete slab or a wet screed
